0% Complete
صفحه اصلی
/
پنجمین کنفرانس بین المللی میکروالکترونیک ایران
Synthesis of TiNb2O7 by mechanical alloying and subsequent heat treatment as an anode material for Li-ion batteries
نویسندگان :
Shiva Rashidi Kia
1
Mehdi Khodae
2
1- دانشگاه صنعتی خواجه نصیرالدین طوسی
2- دانشگاه صنعتی خواجه نصیرالدین طوسی
کلمات کلیدی :
TiNb2O7،mechanochemical synthesis،ball milling،Li-ion battery
چکیده :
Lithium-ion batteries are widely used as rechargeable power sources for various devices. One of the main challenges in lithium-ion batteries is achieving high charging speeds. For this purpose, titanium-niobium-oxygen compounds are used as new anodes for lithium-ion batteries. Mechanochemical synthesis consisted of high energy ball milling of constituents followed by a heat treatment process is one of the solid-state methods that can be used to synthesize this material. In this work, the nanostructured TiNb2O7 has been synthesized by ball milling of TiO2 and Nb2O5 raw materials and subsequent heat treatment. The structural, morphological and elemental characterizations have been done by XRD, SEM, and EDS analysis, respectively. The electrochemical properties of batteries were measured by rate performance and capacity retention tests. These tests show that the samples retain 65% of their initial capacity after 200 cycles, and batteries contain more than 85% of their initial capacity after 45 cycles.
لیست مقالات
لیست مقالات بایگانی شده
Impact of Geometrical and Process Design Parameters on the Performance of Schottky Barrier Reconfigurable Field Effect Transistor
Hamid Reza Heydari - Zahra Ahangari - Hamed Nematian - Kian Ebrahim Kafoori
A Low-Noise Amplifier with Bandwidth Extension and Noise Cancellation for 5G Receivers
Pardis Javanbakht - Mortaza Mojarad
Three-Phase Bidirectional Integrated Meter Using Hall Effect Sensor in 0.5um CMOS Process
Shayan Anzali - Morteza Mousazadeh - Khayrollah Hadidi
طراحی و شبیهسازی جمع کننده 64 بیتی سریع با استفاده از ترانزیستورهای نانو لوله کربنی (CNTFET)
علیرضا جعفری تازه کند - جواد جاویدان
Design of a High Voltage Common Mode Resilient FlexRay Receiver in 180nm/5V CMOS Process
Hamid Sadat Mansoury - Saeed Saeedi - Mojtaba Atarodi
A Low-Power Fully Differential LC Oscillator with Phase Noise Reduction for LTE Applications
Yeganeh Moradzadeh Rezaei - SIROUS TOOFAN - Jafar Sobhi
طراحی و شبیهسازی شمارنده بالا و پایین شمار چهارسطحی با استفاده از تکنولوژی 32nm-CNTFET
جواد جاویدان
Current-Mode Wideband Frontends With Linearity Enhancement for 5G Receivers
Adibeh Rahmani - Mortaza Mojarad - Seyed Sadra Kashef
Using GDI Structure in Hardware Implementation of Convolution Operation in Deep Neural Networks
Maedeh Kadkhodaie - Sayed Masoud Sayedi
Third Harmonic Generation Improvement with BIC based Perovskite Metasurface
Fateme Momeni - Vahid Ahmadi
بیشتر
ثمین همایش، سامانه مدیریت کنفرانس ها و جشنواره ها - نگارش 41.5.5